Check Input
To Check Timesheet Input:
-
Click the Check button and wait for the Pay Point Batch Control Summary to appear.
-
If any errors are found during the check these will be highlighted.
-
The Summary will display a number of totals by pay point. These totals include:
-
Ordinary, Overtime and Penal time hourly totals
-
Salary hours total
-
Paid Total Paid employees
-
Unpaid Total employees with no Payment entries
-
Cleared Total employees with no transactions.
-
-
If you want to clear transactions for unpaid employees, click the Clear Unpaid button and check again. The remaining deductions for these employees will be removed and the unpaid total will be added to the cleared total. You can nominate Payments at this point to be ignored in the Unpaid Check process if they have a quantity but no rate value. These Payments could be used to record Hour or Day units to be accumulated in the employee's Leave History and subsequently used in the calculation of Annual Leave rates (Maternity Leave for example).
-
A report of the unpaid and cleared employees can be printed by clicking the Unpaid/Cleared button:
-
When finished, Click the Next button.
Invalid Transaction Combinations
If you received a Check Input message regarding "Invalid Transaction Combination" this would have been activated by the following scenario:
Termination of an employee generates a "Holiday Pay Owing" transaction used to pay a percentage of gross earnings as final holiday pay. The very nature of this payment requires that all payments within the final pay must be calculated prior to the calculation of this holiday pay.
If the "Holiday Pay Owing" transaction is flagged to accumulate into "Company Superannuation Contribution Earnings" and/or one of the "Special Total" accumulators and the employee in question has a payment which has a calculation method based on a percentage of either of these accumulators then there is an "infinite" calculation issue.
We recommend that to alleviate this issue, terminate the employee in a non-standard pay run after all period payments have been made. During this non-standard run de-select the accumulation indicators on the "Holiday Pay Owing" payment and reset these after the non-standard pay has been closed.
The "Invalid Transaction Combination" issue may also occur with a "Casual Holiday Pay" payment with accrual settings the same as the "Holiday Pay Owing" payment above.
To see this page:

on the